What should be paid attention to when using the medium wire cutting machine?

Time:2019-09-24 05:59:17
The medium wire walking WEDM reduces the error caused by material deformation and molybdenum wire loss through multiple cutting, so that the processing quality is relatively improved. The processing quality can be between the high-speed wire walking machine and the low-speed wire walking machine. Let's take a look at what we should pay attention to when using.

 
 

1. The safety protection devices such as the wire conveying assembly and the workbench cannot be opened during the wire conveying and processing of the medium wire cutting machine tool, and the corresponding protective devices are marked with warning signs to pay attention to safety during use;

2. It is strictly forbidden to cross the safety protection device during the operation of the medium wire cutting machine tool;

3. During the operation of the machine tool, it is strictly forbidden to touch the electrode wire to avoid accidents;

4. When the machine tool is running and the electrical cabinet is powered on, it is forbidden to open the electrical door to avoid accidental electric shock;

5. Do not disconnect the coolant for a long time during the processing to avoid affecting the processing speed and accuracy, and damaging the electrode wire;

6. The machine tool electric appliance is equipped with mushroom emergency stop switch. In case of emergency, press the emergency stop to switch on and off;

7. The electrical appliances of the machine tool shall be protected against lightning strike and lightning arrester shall be installed;

8. The protective cover of the machine tool is not interlocked with the start of the machine tool. Please pay attention to the use of the protective cover during processing;

9. The power must be cut off during maintenance and guarantee;

0. Wear protective tools during clamping and unloading to prevent hands and feet from being injured;

. The workpiece must be cleaned at the designated position, and protective tools such as goggles, masks, anti-skid shoes must be worn;

2. When the machine tool is abnormal, such as abnormal noise, smoke, vibration, odor, etc., the machine tool should be shut down immediately, and relevant personnel should be asked to check and deal with it.

After reading the sharing brought by Xiaobian, if you are interested in our products, please contact us in time, and we will serve you wholeheartedly. Welcome to inquire!

Hotline:
0519-85282518
Mobile:13092513723
Email:czboruige1@czboruige.com